Replacement of a FB bar screen
Last week, in the Ile-et-Vilaine department, we replaced a bar screen of our own brand, installed in 2002. The new bar screen is now made exclusively from 304L stainless steel, whereas the previous one was made from hot-dip galvanized steel (at least the upper frame).
The special feature of this installation is that it is located in an urban area, in a buried substation. Handling is therefore more complicated. It took our two technicians just one day to carry out the equipment replacement.
An operation punctuated by commissioning, testing and fine-tuning.
TECHNICAL DATA
Supply of a automatic bar screen
- Type NG11
- ALL STAINLESS STEEL 304L
- Flow rate 3000m3/h
- 25mm air gap
- Depth under countertop 2200mm
- Two-piece chassis
Options retained
- On-site transport
- Dismantling existing equipment
- Assembly of new equipment
- Testing, adjustment and training of operating personnel
Project photos
Screen installed in 2002
Dismantling the existing bar screen
Handling the new bar screen
Screen seen from outside the manhole
Downstream view of the new grille
New bar screen